SEAD 3000/6000- Subtle Energy Activation Devices (**OLD SPARK GAP Technology)

1240933The SEAD 3000/6000 and Tesla Energy Lights are essentially the same machine with only minor differences.

Both these machines have a much smaller tesla coil and weaker output than the Biocharger, VIBE / Quantum Pulse and Novalite.Also, because they lack the toroidal coil on top, the frequency range is not as rich either.

Description by Manufacturer:

The SEAD is a pulsed electromagnetic frequency (PEMF) device that produces five kinds of energy: Bio-photonic, electromagnetic, Bio-electrical, light frequencies and radio frequencies. Devices of this type are commonly called Multiwave Oscillators (MWO’s); a term derived from the high frequency wave oscillations that the units produce. The SEAD is the result of more than 20 years of research and development based on the technologies of Georges Lakhovsky, Nikola Tesla and Royal Rife.

The SEAD is constructed using an ultrahigh frequency air core resonant transformer, specially designed Tesla Coils and spark gap electrodes. The rich pulsed electromagnetic field and high frequencies charge and activate various inert and common gases (Hydrogen, Helium, Neon, Argon, Krypton, Xenon, Nitrogen, Oxygen, Air and Water Vapor) in an Air Plasma Tube and Multitube Array. These gases have been selected, by research and experiment, for their individual and separate properties. When activated, they produce specific frequencies that cannot be generated any other way. Additionally, experimentation with the location of each different gas tube led to them being organized according to the richest subtle energy field output.

The REAL Truth Behind the SEAD and Tesla Energy Lights Machine

380575SEAD and Tesla Energy Lights offer an adjustable spark gap to allow for users to increase output.  They are unable to increase the output too much, because it will burn out the transformer, as stated by a distributor.  The reason for this is that the Tesla coil inside of the box is too small and too close to the transformer.  When the spark gap is opened too much, the output from the Tesla coil will arc to the transformer and cause it to burn out.  They have an adjustable spark gap, but it is not recommended to use it.  They state on their websites that the adjustable spark gap is patent pending.  If you refer to the two patents by James Girard, you will see the adjustable spark gap was patented by him in the 1990’s.

Some research was conducted using a spectrum analyzer to compare the output of the DC based unit versus the AC unit/circuit which revealed virtually no difference between the spectrums of frequencies each produced.  The only difference was that the polarity of the magnetic field around the primary coil changed in AC.  The magnetic field of the primary will not influence any living systems, because it is inside of the base and the field is very small.  Any living system would need to be touching the base of the SEAD or Tesla Energy Lights to be affected.

On a separate note: true benefit has been realized by designing the BioCharger NG with (2) DC power supplies, which eliminates the 60Hz carrier signal and allows for cleaner and clearer tones, produced by the corona discharge from the Arc Rod.

Proof that SEAD Machines and Tesla Energy Lights are Knockoffs of the BELS Biocharger

Although Tesla Energy Lights claim in their literature that the BELS mentioned in their website is a device they invented, their agreement states otherwise.

Under Sead or Tesla energy lights, it refers to patent listing James Girard as inventor filed June 19, 1997.  Highlighted sections refer to an adjustable spark gap and DC systems which use rectified voltage from transformer, and a description of an adjustable spark gap that Tesla Energy Lights and SEAD claim is patent pending.  This patent acknowledges James Girard as inventor of DC BELS with light emitting system with adjustable spark gap, and does not use a flat spiral pancake coil as defined in agreement with Mark, Ken and Kent.  Ken, Kent, and Mark were not listed as inventors, because the patent did not incorporate a flat spiral pancake coil as defined in their agreement.

Proof is provided in the official legal documents below…

The REAL History of the BELS Multiwave Oscillators

Jim began researching Tesla coils and Multiwave Oscillators (MWOs) in 1988 in Ohio.  He built a variety of coils of different sizes and shapes, including a Bipolar Tesla coil where he attached a Multiwave antenna to each end of the coil.  Some of these systems produced corona discharges in excess of 10 ft.  He also experimented with a variety of plasma gases, including neon and argon bulbs purchased from a neon sign shop.  Jim also experimented extensively with AC current and DC current on the primary coil, which led him to explore the use of spectrum tubes containing various noble and inert gases to form a visible light component as he investigated the benefits of a wider range of pulsed frequencies.