Tesla Energy Lights - Same As SEAD w/ a few new add-ons (**OLD SPARK GAP Technology)
Essentially the same as the SEAD 6000 and 12,000.
Description from Manufacturer:
Tesla Light System - Tesla Energy Lights™ is a personal energy management system designed to donate electrons, recharge and permeate one's subtle energy bodies with compatible high frequency subtle energy.
Although this life force known as subtle energy is an unseen commodity like the air we breathe, it is as necessary to be alive in all people, animals and plants. The Lights™ are specially formulated to deliver a full spectrum of harmonic ions emanating from exclusive proprietary noble gas crystal tubes. Exposure to these frequencies sitting or lying empowers the user to manage their thoughts, feelings and belief system subtle energies by directing them with one's own will and intentions. These energies can be measured objectively on the GDV (Gas Discharge Visualization) camera that reveals each and every person may observe many energy shifts as a result.
Nikola Tesla inventor of AC and wireless subtle energy transmission technology, contributed in the early 1900's with his invention of the Tesla Coil. Since 1994, the producers of the Tesla Energy Lights™ have been refining this original pulse technology quantum system designed to produce in excess of 200% more available frequencies via “heterodyning”.
Heterodyning is possible by employing the yin and yang principle harmonizing in our exclusive uni-polar dual bias system incorporating 2 opposite wave forms. Using a single polarity unit only would amount to about 1/3 the potential otherwise. Utilizing 2 complemetary units in synergy is very efficient while expanding. Our exclusive proprietary magnetic crystals augment the effect during the Tesla Energy Lights™ session, as well as AFTER the session.
The REAL Truth Behind Tesla Energy Lights
SEAD and Tesla Energy Lights offer an adjustable spark gap to allow for users to increase output. They are unable to increase the output too much, because it will burn out the transformer, as stated by a distributor. The reason for this is that the Tesla coil inside of the box is too small and too close to the transformer. When the spark gap is opened too much, the output from the Tesla coil will arc to the transformer and cause it to burn out. They have an adjustable spark gap, but it is not recommended to use it. They state on their websites that the adjustable spark gap is patent pending. If you refer to the two patents by James Girard, you will see the adjustable spark gap was patented by him in the 1990’s.
They also state on their website that they are the only ones with DC. This is not the case. Advanced Technology Concept also patented the DC circuit in the 1990’s. Advanced Technology Concept measured the output with a spectrum analyzer and compared it to a circuit using AC and noticed no difference in the spectrum of frequencies. The only difference is the polarity of the magnetic field around the primary coil changes in AC. The magnetic field of the primary will not influence any living systems, because it is inside of the base and the field is very small. Any living system would need to be touching the base of the SEAD or Tesla Energy Lights to be affected.
Proof that the SEAD and Tesla Energy Lights are Knockoffs of the BELS Biocharger
The agreement between Advanced Technology Concept, a partnership between James Girard and Douglas Oringer, and Mark Hoffman, Kent Noonan, and Ken Bentall. This agreement states that Advanced Technology Concept owns all technology related to using a spark gap Tesla coil, a plurity of plasma tubes using a flat spiral pancake coil as a third coil. The technology is more particularly specified in Appendix A titled “BELS”. Although Tesla Energy Lights claim in their literature that the BELS mentioned in their website is a device they invented, their agreement states otherwise.
Under Sead or Tesla energy lights, it refers to patent listing James Girard as inventor filed June 19,1997. Highlighted sections refer to a adjustable spark gap and DC systems which uses rectified voltage from transformer, and a description of a adjustable spark gap that Telsa Energy Lights and SEAD claim is patent pending. This patent acknowledges James Girard as inventor of DC BELS with light emitting system with adjustable spark gap, and does not use a flat spiral pancake coil as defined in agreement with Mark, Ken and Kent. Ken, Kent, and Mark were not listed as inventors, because the patent did not incorporate a flat spiral pancake coil as defined in their agreement.
The REAL History of the BELS Multiwave Oscillators
Jim began researching Tesla coils and Multiwave Oscillators (MWOs) in 1988 in Ohio. He built a variety of coils of different sizes and shapes, including a Bipolar Tesla coil where he attached a Multiwave antenna to each end of the coil. Some of these systems produced corona discharges in excess of 10 ft. He also experimented with a variety of plasma gases, including neon and argon bulbs purchased from a neon sign shop. Jim also experimented extensively with AC current and DC current on the primary coil.
Doug Oringer 1st met Jim Girard by phone in 1992, and then later in person in June 1993 when Jim married his sister Deirdre. Doug and Jim shared similar interests in alternative medicine and energy. Doug eventually invested in Jim’s research and the two formed a partnership - Advanced Technology Concepts (ATC) in late 1994. Jim first built several Tesla coils with 3 bulbs on top of it. He then found a good source for variety of vacuum-gas spectrum tubes, which he ordered in order to investigate using a wider range of frequency in the visible light spectrum.
Doug initially introduced Jim to the book Let There Be Light, color therapy work from the turn of the century byDarius Dinshah. Dinshah utilized visible light for healing and Doug wanted to try and produce a unit that offered a complete rainbow-array of colors to mimic and incorporate Dinshah’s work.
Mark Hoffman, a contractor who Jim worked with doing construction, found a PVC floor-drain he suggested we use to help support all the plasma-gas vacuum tubes we were experimenting with. Mark then apparently bought one at the local hardware store and brought it over to Jim’s. After that, the early BELS prototypes utilized this PVC floor drain assembly as the carousel structure for the vacuum tubes.
ATC began manufacturing this device and called it a Bio-Electric Light Stimulator (BELS) unit. This name was coined by Mr. Ken Bentall, who Doug had paid to provide intuitive feedback on impressions of the energy field(s) produced by the BELS, various plasma-gases used, and several other machines Jim built.
ATC also hired Kent Noonan to build an interface for a Rife Machine. ATC purchased a short wave radio and function generator to build a Rife Machine, and Kent was paid cash to build an interface between the function generator and short wave radio. Kent was interested in Lakhovsky’s work also, and had built several systems himself, but he was interested in using only solid state technologies.
In late 1994, Jim built his first pancake coil, which measured approximately four feet in diameter. In order to further investigate the BELS technology, Jim proceeded to assemble 5 separate pancake coil systems. This pancake coil* version of the machine was very large, heavy and awkward. The base-box measured approximately 4-feet square and 2 feet high, with the secondary coil-stack extending another 2 to 3 feet up through the top of the box. That particular design weighed several hundred pounds, and required all kinds of special-handling and unique FOB - [freight of billing] shipping costs.
In 1996, ATC, Mark Hoffman, Kent Noonan, and Ken Bentall decided to part ways with ATC. ATC signed an agreement with them which acknowledged ATC owned the rights to all the BELS technology developed. ATC acknowledged that Mark, Ken and Kent co-invented a single pancake coil* version of the BELS - the large, heavy, awkward, bulky model that used the pancake coil version, the version which never sold, because it was too large, heavy and awkward for most people. Although they all make claims they invented the BELS shown in photograph on their website, this is not the version they agreed to in their written legal agreements with ATC (see attachment).